PRIVATE USE ONLY. CONTACT FOR COMMERCIAL USE

So Here is the ACC_PREMIER internal weight and barrel bridge. NOTE: This is a 4 part file. make sure you download all four parts and print as many bridge section to need to accommodate your scope.

This is for R700 inlets and should work on other models but may need some mods

The two inserts will replace your internal weights but you can add the weight back in the form or birdshot inside the insert. ( up to 2lb)

This will accommodate a 32mm barrel

once the two inserts are glued and screwed in( mounted from the bottom into M3 or M4 inserts ) you can fill the insert from the front and cap it with the new nose cap. The side and bottom MLOK at still fully usable for additional weight or accessories.

You will need M3x3.5 or 4mm heat inserts at least x50 and x50 M3 by 8mm hex key screws ASA for best durability, print both inserts vertical for best strength and quality

These are both accent and functional prints. if you print the inserts in a accent color and the caps are the same color as your frame, your M lok slots will be contrasted