This is a remix of Skadis Benchy display as I am mixing up my board system with Skadis and Multiboard. Tolerances for the push fit part may need to be adjusted as it seems to be a thing with Multiboard prints. 

It won't let me post the model that I used for the remix:

https://www.printables.com/model/606737
Skådis Benchy 30° Display Shelf 

Multiboard Benchy Shelf 30° Display

Benchy_Shelf.3mf

One of my first remixes so if there any suggestions, please let me know. After shifting from Skadis to Multiboard, I made this for my husband so he could keep his USB cable winders. I used Orca Slicer so I could set the support tree branch density to 45%. It should still work in Bambu Studio without that. Due to the orientation of the model, I went ahead and put the screw in cap to be on the safe side. Mine was able to stick to the boards I printed, but again, it's more of a precaution.

If there are any issues or questions, please let me know. Thanks!

Where I got the model for the remix:

https://makerworld.com/en/models/170648?designId=170648#profileId-187318
Storage Box for Portable Cable Organizer Skadis

The cable winder:
https://makerworld.com/en/models/13849#profileId-13650
Portable Cable Organizer / Winder

Storage for Portable Cable Organizer- Multiboard

USB_Winder_Holder_v2_2.3mf

I made this as a challenge to myself so I could finally go through with modeling as well as trying to make more things for my Multiboard system. This is my second model that I've design from scratch with the exception of the snaps on the back. There is a small amount of space vertically due to the measurements that I got from iFixit's site are a little thicker than the case I have. The width is fine.  Make sure that when printing with supports, change it to “On build plate only” or else you'll get supports in the tiny spaces in the snaps.

iFixit Manta Kit Multiboard Mount

iFixit_Case_Only.3mf

This is the push fit version for the printer test model from here, https://www.printables.com/model/271350-mini-all-in-one-printer-test by Ty10y.  The lower shelf on the second pic is the push fit version as I also made a snap version.  Tolerances are a known thing so your setting may need to be adjusted accordingly.

Multiboard Benchy Shelf 30Deg Mini AIO Test Card Holder- Push Fit Ver

MB_Benchy_Push_Fit_Ver.3mf

3D printing since the beginning of 2024.  Still new at a lot of it and designing models.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Invader_Akira

Achievements

Voyager

Seedling