Profile Image
Ian_Smalley
Ian_Smalley

Ian_Smalley

Hueforge tester, creating 3d printed filament paintings, using 3d printers to create art

Follow

Select a membership plan

$5.00
/ month

Welcome and thankyou for the support, This tier gives you early access to all of my designs and access to exclusive member only models to print for personal use only.

Please note the files are not to be re-distributed or used for financial gain.

Ian_Smalley

Sydney 'Time Zone' Clock

by
Ian_Smalley
Follow
Follow
Remix Model
Ian_Smalley
Ian_Smalley
|
Image 1 of 2
Sydney 'Time Zone' Clock 3d model
Ian_Smalley
Ian_Smalley
|
Image 1 of 2
Sydney 'Time Zone' Clock 3d model
2D
3D
Makes
Sydney 'Time Zone' Clock 3d model
Sydney 'Time Zone' Clock 3d model

5 Colour Tokyo ‘time zone’ clock, made using Bambu filaments.

Filament painted print made using HueForge - Filament swaps ONLY, no mmu/ams required

(I recommend the following max speed settings, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm

Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Basic Green Transmission Distance: 2.5 PLA Bambu PLA Matte Grass Green Transmission Distance: 2 PLA Bambu PLA Matte Lemon Yellow Transmission Distance: 3 PLA Bambu PLA Matte Ivory White Transmission Distance: 4

PLA Bambu PLA Matte Mandarin Orange transmission distance: 3

Swap Instructions: Start with Charcoal At layer #4 (0.36mm) swap to Green At layer #11 (0.64mm) swap to Grass Green At layer #16 (0.84mm) swap to Lemon Yellow At layer #20 (1mm) swap to Ivory White At layer #33 (1.52mm) swap to charcoal for the border

At layer #39 (1.76mm) swap to Mandarin Orange or choice of colour for the numbers/text

I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results

Use the exact numbers in your slicer to match up properly.

The Model is designed to print with 0.4 nozzle.

If re-scaling model make sure not to alter the Z height of the model

add a negative cylinder to the Centre of the clock in the slicer to create the correct size hole for your movement or alternatively drill the required size hole.

Link for the movement that I used is listed below but any standard movement will be fine (be sure to check the size of the hands)

https://www.amazon.co.uk/dp/B0BBLXG55S?psc=1&ref=ppx_yo2ov_dt_b_product_details

ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.


2 Likes11 DownloadsNovember 13, 2023




2 Likes11 DownloadsNovember 13, 2023