Samurai training camp 'Filament Painting'
6 Colour ‘filament painting’ model, Samurai Training Camp
(I recommend the following max speed settings, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used: PLA Sunlu PLA+ Black Transmission Distance: 0.6 PLA Esun PLA+ Fire Engine Red Transmission Distance: 5 PLA Esun PLA+ Bone White Transmission Distance: 4 PLA Sunlu PLA+ Orange Transmission Distance: 8 PLA Sunlu PLA+ Pure Yellow Transmission Distance: 5 PLA Sunlu PLA+ White Transmission Distance: 6
Swap Instructions: Start with Black At layer #6 (0.56mm) swap to Fire Engine Red At layer #9 (0.8mm) swap to Bone White At layer #13 (1.12mm) swap to Orange At layer #14 (1.2mm) swap to Pure Yellow At layer #15 (1.28mm) swap to White for the rest.
I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results
Use the exact numbers in your slicer to match up properly.
The Model is designed to print with 0.4 nozzle.
If re-scaling model make sure not to alter the Z height of the model
ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.