6 Color HueForge model. 'Rocket Clock' filament painting made using Bambu Pla Matte filaments.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Matte Scarlet Red Transmission Distance: 2 PLA Bambu PLA Matte Mandarin Orange Transmission Distance: 3 PLA Bambu PLA Matte Lemon Yellow Transmission Distance: 4 PLA Bambu PLA Matte Marine Blue Transmission Distance: 2 PLA Bambu PLA Matte Ivory White Transmission Distance: 4

Swap Instructions: Start with Charcoal At layer #6 (0.56mm) swap to Scarlet Red At layer #11 (0.96mm) swap to Mandarin Orange At layer #12 (1.04mm) swap to Lemon Yellow At layer #14 (1.2mm) swap to Marine Blue At layer #15 (1.28mm) swap to Ivory White for the rest.

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results

Use the exact numbers in your slicer to match up properly.

The Model is designed to print with 0.4 nozzle.

If re-scaling model make sure not to alter the Z height of the model

Mark the Centre at the rear and drill the required size hole for your clock movement.

Link for the movement that I used is listed below but any standard movement will be fine (be sure to check the size of the hands)

https://www.amazon.co.uk/dp/B0BBLXG55S?psc=1&ref=ppx_yo2ov_dt_b_product_details

ALL Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.