3 colour HueForge model. Pirate Silhouette filament painting made using Sunlu pla+ filaments
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.28mm
(I recommend the following speed settings for the Bambu, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)
Filaments Used: PLA Sunlu PLA+ Black Transmission Distance: 0.6 PLA Sunlu PLA+ Orange Transmission Distance: 10 PLA Sunlu PLA+ White Transmission Distance: 7
Swap Instructions: Black until layer #4 at 0.52mm Orange until layer #10 at 1mm White for the rest.
This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results
Use the exact numbers in your slicer to match up properly.
If re-scaling model make sure not to alter the Z height of the model
ALL Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.