Filament painted print made using HueForge - Filament swaps ONLY, no mmu/ams required
3 Colour ‘Filament Painting’ model - Op-Art Zebra Portrait, made using Bambu filaments.
(I recommend the following speed settings for the bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)
Leave The Aux fan off on the bambu as it causes more harm than good on these larger prints
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm
Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Tough Cream White Transmission Distance: 10 PLA Bambu PLA Matte Ivory White Transmission Distance: 4
Swap Instructions: Start with Charcoal At layer #7 (0.48mm) swap to Cream White At layer #22 (1.08mm) swap to Ivory White for the rest.
This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results.
Use the exact numbers in your slicer to match up properly.
Two different size models are supplied and designed to print with 0.4 nozzle
If Scaling the model make sure not to adjust the Z-Height of the model
ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.