tracking pixel
Ian_Smalley

Jurassic Park logo badge (fan art swap at layer height)

by
Ian_Smalley
Follow
Follow
Remix Model
Ian_Smalley
Ian_Smalley
Image 1 of 3
Jurassic Park logo badge (fan art swap at layer height) 3d model
2D
3D
Makes
Jurassic Park logo badge (fan art swap at layer height) 3d model
Jurassic Park logo badge (fan art swap at layer height) 3d model
Jurassic Park logo badge (fan art swap at layer height) 3d model
19 Likes32 DownloadsDecember 19, 2023


print made using HueForge - Filament swaps ONLY, no mmu/ams required

Print at 100% infill with a layer height of 0.16mm with a base layer of 0.24mm

Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Matte Scarlet Red Transmission Distance: 1.5 PLA Bambu PLA Basic Yellow Transmission Distance: 3 PLA Esun PLA+ Cold White Transmission Distance: 2.5

Swap Instructions: Start with Charcoal At layer #7 (1.2mm) swap to Scarlet Red At layer #9 (1.52mm) swap to Yellow At layer #11 (1.84mm) swap to Cold White for the rest.

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results. (the white needs be really opaque) matte filaments work best

Use the exact numbers in your slicer to match up properly.

Two different size models are supplied and designed to print with 0.4 nozzle

If Scaling the model make sure not to adjust the Z-Height of the model

ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.


19 Likes32 DownloadsDecember 19, 2023




19 Likes32 DownloadsDecember 19, 2023