Isometric Cube Seamless Cladding (Filament Painting)

Filament painted print made using HueForge - Filament swaps ONLY, no mmu/ams required

2 Colour ‘Filament Painting’ model - Isometric Cube Seamless Cladding

(I recommend the following speed settings for the bambu with 0.04 layers, inner walls, outer walls and gap infill - 200mm/s, sparse infill, internal solid infill and top surface - 150mm/s)

Leave The Aux fan off on the bambu as it causes more harm than good on these larger prints

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm

Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Matte Ivory White Transmission Distance: 4

Swap Instructions: Start with Charcoal At layer #14 (0.76mm) swap to Ivory White for the rest.

Virtually and colour combination will work as long as the second colour has a Transmission Distance of 2 or higher - MIX IT UP! and show me your results

Use the exact numbers in your slicer to match up properly.

If Scaling the model make sure not to adjust the Z-Height of the model

ALL of Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.

Source Image by renata.s on Freepik