7 Color HueForge model. Darth Vader ‘Pop Art’ filament painting made using Bambu PLA Matte and PLA Basic filaments.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used: PLA Bambu PLA Matte Charcoal Transmission Distance: 0.6 PLA Bambu PLA Matte Dark Blue Transmission Distance: 1 PLA Bambu PLA Matte Ice Blue Transmission Distance: 3.5 PLA Bambu PLA Matte Scarlet Red Transmission Distance: 2 PLA Bambu PLA Basic Yellow Transmission Distance: 6 PLA Bambu PLA Basic Bambu Green Transmission Distance: 8 PLA Bambu PLA Matte Ivory White Transmission Distance: 4

Swap Instructions: Charcoal until layer #7 at 0.64mm Dark Blue until layer #8 at 0.72mm Ice Blue until layer #10 at 0.88mm Scarlet Red until layer #14 at 1.2mm Yellow until layer #17 at 1.44mm Bambu Green until layer #18 at 1.52mm Ivory White for the rest.

This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results as this print uses mostly very low td filaments

Use the exact numbers in your slicer to match up properly.

Two different size models are supplied and designed to print with 0.4 nozzle

If re-scaling model make sure not to alter the Z height of the model

ALL Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.