5 colour HueForge model. ‘Sunlu colosseum’ filament painting made using Sunlu pla+ filaments (as seen on sunlu website under hueforge filament packs)
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used: PLA Sunlu PLA+ Black Transmission Distance: 0.6 PLA Sunlu PLA+ Red Transmission Distance: 8 PLA Sunlu PLA+ Orange Transmission Distance: 10 PLA Sunlu PLA+ Pure Yellow Transmission Distance: 5 PLA Sunlu PLA+ White Transmission Distance: 6
Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Red At layer #10 (0.88mm) swap to Orange At layer #12 (1.04mm) swap to Pure Yellow At layer #13 (1.12mm) swap to White for the rest.
This is a filament blending model, I would recommend trying to match the td as close as possible if not using the exact filaments to get the best results
Use the exact numbers in your slicer to match up properly.
If re-scaling model make sure not to alter the Z height of the model
designed to print with 0.4 nozzle
ALL Ian Smalley's designs are protected by Copyright Law. Downloading does not give you permission to use the files or physical prints for financial gain. If you want a commercial license to Legally sell prints from my designs, you will need a SELLER subscription.