The famous Umea lamp now as a table top version. Fits a Bambulab A1 mini (so kind of every printer out there)
Print settings: Shade: vase mode/spiralize outer contour layer height 0.2mm print it upside down and set bottom layers to 4 (see last picture) variate line width for less/more diffusion (0.4-1.0mm) Top: prints upside down 0.16mm layer height 3 walls minimum review position of z-seam Cap: 0.2mm layer height 2 walls 2 bottom layer 0 top layer 30% gyroid Clip: use a brim Retainer, Adapter: 0.16mm layer height 3 walls 30% gyroid
Filament: For the shade use some whiteish filament. I used Spectrum PLA Ivory Beige.
Additional hardware: 4x wood rods diameter=20mm L=205mm 8x wood screw 3x20mm 1x E14 light cord For drilling the leg you need a long enough 8mm drill For drilling the adapter holes use a 2mm drill