Anycubic Photon Mono SE door handle.stl

this model uses a threaded heat insert and a screw to replace the original handle for the Anycubic Photon Mono SE

Tutorial: Once the model is printed you must use a soldering iron to carefully melt the insert into the hole on the bottom of the model, Be sure to keep the soldering iron straight because if the threads are misaligned your handle will be misaligned as well. Once the threaded insert is in the model you should test your screw to make sure the threads aren't misaligned. If the insert is aligned properly you insert the screw from the inside of the door where the threads are poking outside the printer then you twist the handle onto the screw until the handle is completely tightened against the door.