The BrickBrack system is something that I have invented in order to allow quick swapping of your favorite accessories between your wall, pegboard or skadis board. It even includes a mini pegboard that can be attached to your wall or skadis board using the same bracket.

I have lots of ideas for more accessories and art too that I would love to make available for this system.

This is the starter pack. I have more accessories available and I will continue adding more on my Patreon

My favorites so far are the mini pegboard and the XL mushroom shelf. Everything is compatible with the brackets and there are 3 types of brackets. Wall, Skadis, Standard Pegboard (1/8 inch thick with 1/4 inch holes and 1 inch spacing).

Most of the accessories will need some support. I have found that tree supports at about 60 degrees is plenty for most.

All of the brackets can be printed support free given they are placed flat side down. In my testing everything fits nicely. You might have to scale your brackets by 1-2% if they are too loose or tight based on things like under/over extrusion or other factors unique to your machines.

As I make and test more accessories I will add them here. If you have any issues please let me know. I want these to be as printable and usable as possible.

For the wall bracket I would recommend screwing into a stud or using wall anchors with your screws.

Enjoy!

Accessories should be printed with at least 25% infill and use tree support at 60 degrees for most of them.

Brackets should have at least 50% infill and 3 walls, oriented flat side down and no support needed.