DIFFUSER TRAY / DISPLAY TRAY FOR WALL, PEGBOARD OR SKADIS

This was designed for holding an essential oil diffuser. The diffuser version has a hole to run the power cord through and there is even a clip inside the hole to hold the wire in place if you unplug the diffuser to move or clean it.

It goes with my BrickBrack system for mounting to wall, standard pegboard or ikea skadis board.

Members get access to my premium files and authorization to use the prints commercially.

3D PRINTING SETTINGS The tray should be printed on it's back with 80 degree supports touching the buildplate. You can pry the supports out of the cavity with a buildplate scraper or similar tool. >15mm resolution > 10% infill.

The brackets can be printed flat side down without support. You should print the brackets with atleast 50% infill and 3 outer walls.