The wife needed some sturdy trellises for her house plants. Nothing that I found quite fit the bill for what she was looking for, so I quickly made my own.
Customizable: Print the ladder piece and use by itself or connect multiple together using a couple of options.
1. Pegs: small pegs fit inside the ends of the ladder pieces to connect 2 ladders together or use as spikes to plant the ladder in the dirt. They do work but are a little flimsy. 2. Connectors: These slip over the ladder ends to connect two ladders together. Much sturdier. Tolerances built into the model to allow for an easy fit, depending on your print settings. If it's too loose, you can always use a little glue. 3. Spikes: two difference lengths provided, 80mm and 40mm. These are intended to be placed on the ladder ends to hold the trellis up in the dirt.
All pieces are meant to print as oriented in the file. No supports or brim needed, as long as your build plate is clean.