Criss Cross Dice Tower with dice tray - one piece - no supports

Was looking for certain kind of dice tower, that wasn't out there. One where the baffles directs the dice to hit off the side wall to give the dice a spiral spin. I thought i’d create this new kind of dice tower.

It is a dice tower with criss cross walls, uses Triangular Baffles to bounce the dice off the insides of the 4 walled tower, resulting in a clockwise dice roll.

[*] Designed to roll dices in clockwise spiral down the tower

• 3 directional baffles to bounce dice off the side walls,
• Final roll in the catch tray.

[*] Suits Dice of Do= 26 mm ( 1 inch ) outer diameter dice size, even your D30’s

[+] Designed to be printed upright, with no supports:-

[-] Max. layer height is 0.20mm - don’t go any higher due to slope angles, keep at 0.2mm or less.

[+] Designed for no infill:-

[-] Needs at least 4 or 5 top & bottom layers thickness - for corner strength, there lots of corners on this thing

[*] It is 210mm high expect 14+ hours or more print time:-

[-] Don’t scale it down, otherwise the tower won’t work, and some dice will get stuck. it needs sufficient spaces ‘bounce gaps’ to bounce dice off the walls.

[-] Don’t reduce the height, otherwise overhangs become too shallow and wont print.