.png&w=3840&q=85)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
.png&w=256&q=75)
Desktop Basketball
2K downloads · 2 years ago · [Instructions](https://prinnit.com/ForgeCore/design/3686fetd734Ovs5FwP8G0Ub3udv?tab=instructions&hig
Instructions Hardware Filaments
Desktop Basketball - Beginner Desktop Basketball is a super fun way to pass the time when you need a break from your work. It works with any standard ping pong ball and can adjust to fit any size desk.
Desktop Basketball
2K downloads · 2 years ago in and
Spinny Succulents - Pack III
Desktop Golf Gen 2
PlayBook'd - Playing Cards
Desktop Dumpster
PlayBook'd Cribbage
PlayBook'd Crosswords
Snack Attack - Gen 2
PlayBook'd Snakes and Ladders
.png&w=3840&q=75)
Date Night Daisy
PlayBook'd Settlers' Storage
Scoopy Stacks
Butterfly Fridge Magnets - Pack II
Playbook'd - Checkers
PlayBook'd - Shut the Box
PlayBook'd - Hook and Ring.3mf
Paint Can Drying Rack
Mossy Mounds
Playbook'd - Reversi
Playbook'd - Sling Puck
hey I am having trouble getting the net into the rim without breaking the rim
Hi, I'm sorry you're having issues. It was designed to just snap into place. If the filament is breaking you may need to dry it, print with a higher temp, or try a different filament, Basic pla and pla+ are a bit stronger than matte.
I have tried printing the net several times and pieces of it are moving around the build plate and causing spaghetti. Any recommendations? Thank you
I'm sorry to hear you are having issues with it. I do have some recommendations. Start by making sure your build plate is washed with warm water and dish soap and I would also suggest adding a thin layer of glue to a PEI plate to help with the adhesion. Those settings both usually fix this issue. sometimes if you're still having issues you can also slow the print and raise the plate temp 5-10°
Got it to work, thanks!
What type of screw do you recommend?
Any M3.5 x 8 mm screw should work.