It has solvable maze inside.

After solving the maze, the capsule opens and you drink your drink with the pleasure of solving it.

• You can thread a rope around the loop lid and lock it so that it cannot be opened or you can use it for transport purposes.

• Also I made a snap joint so that the cover does not open upwards

There is a caffeine structure (organic formula) on the cover. I advise you to put the appropriate drink in it.

3D printing settings :

• Maze.stl : All 0.2 mm layer height except || 0.08 layer height between(5.70 - 8.00 mm) (You can set it in prusaslicer)

• Cover.stl : All 0.2 mm layer height except || 0.08 layer height between(134.00 - 137.50 mm) Don't forget to turn it upside down

If you want to save some filament you can reduce the number of walls to 2 and make the number of bottom layers and top layers 3, 2 15% infill for Cover.stl 10% infill for Maze.stl

There may be small symmetry errors I apologise in advance :)) Also i remixed it for 12 oz can cup

• I didn't know the exact length of the can, so I made cover a little long. Be aware of it. -I am still in the printing stage, there may be mistakes(there probably is). I will correct them after printing, briefly this model is WIP.

Have fun while printing !!