Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4382611.

A skyrim logo necklace!

Original model by: https://www.thingiverse.com/thing:3042456

I basically adapted it to a simple necklace, thicker, added proper support, an attachment point etc...

Printing!

I included my supported stl's as well as the sliced files for the anycubic photon S.

My print settings: (in use in the pre-sliced file)

Printer: Anycubic photon S

What to print?: 4 double sided skyrim necklaces at once

Time to print?: around 8 hours

Layer height: 0.02 mm

Quantity of resin used: around 20 mL

Type of resin: Anycubic Eco plant-based resin (macaroon pink and blue)

Printing temp: around 20C, the highest I could get at the time

###Washing, Curing

I recommend removing the supports before curing. It's a bit more tedious with gloves and a mask, but they come off easier and there is less risk of damage.

also recommending to cure underwater, just tried with the last batch and they came out great.

###Sanding

I started with 100 grit, then 150, 250, 600 grit.

Basically sand the supports marks until they are flat, then increase the grit to have a smooth finish.

###Painting

I did two thin layers of black primer, then two layers of shiny chrome, short

/!\ WARNING /!\

I left the first three ones I printed on my desk in the sun before painting and they started to warp after 2-3 days. so maybe avoid leaving them in the sun before painting. (or cure them more).

Have fun :)