This is a Cutlery holder that is designed to have 4 compartments. The left front compartment is slightly narrower supportiung for knives, allowing larger widths on the centre and right compartment to asccommodate forks and spoons. The rear coimpartment is designed for less used cutlery supporting chop sticks too.
The External housing is designed to allow easy and convenient sliding of the cutlery holder in and out. There are holes top and bottom of the external housing to support a few different uses. If you want it to be a single component you can use the blanking pins top and bottom. If you would like to fix it to some base, there is 5mm space to accomodate a screw head. With the expansion pin, this allows you to stack these housings on top of eachother easily and with stability.
Please note, the print size required is at least 303030cm.