tracking pixel
Corey M

Retro Single Can Picnic Cooler

by
CM Design
Follow
Follow
Remix Model
CM Design
CM Design
|
Image 1 of 6
Retro Single Can Picnic Cooler 3d model
CM Design
CM Design
|
Image 1 of 6
Retro Single Can Picnic Cooler 3d model
2D
3D
Makes
Retro Single Can Picnic Cooler 3d model
Retro Single Can Picnic Cooler 3d model
Retro Single Can Picnic Cooler 3d model
Retro Single Can Picnic Cooler 3d model
Retro Single Can Picnic Cooler 3d model
Retro Single Can Picnic Cooler 3d model
This model is restricted by licensing terms. 
129 Likes245 DownloadsApril 15, 2022
This model is restricted by licensing terms. 


Sup bros and brahs! Back at-cha with a new cooler design! Need to chill a cold one at a picnic? Got the perfect thing for you! A single can cooler with handles!

Was really inspired by LayerOne3d's single can cooler, check his work out here: https://social.thangs.com/u/110590

Print Settings The Body, and Insulation can be printed without supports. I printed them out at 20% infill with 4 perimeters/shells and it felt rigid.

The Handle needs to be printed flat with supports on the snap detail. I printed this at 20% infill as well.

The Lid can be printed with the top laying down on the print bed but may need supports on the edges. I printed this at 20% infill as well.

Assembly

The Insulation slides into the Body and is pressure fit together, use super glue if needed.

The Handles can snap into the Body after they are cleaned of supports. Make sure that the handles fit together to form an "A-frame" at the center before snapping them in.

The lid will pressure fit into the cooler.

Hope you find this print to be fly!

Let me know if you have any questions or suggestions!


129 Likes245 DownloadsApril 15, 2022




This model is restricted by licensing terms. 
129 Likes245 DownloadsApril 15, 2022
This model is restricted by licensing terms.