Hot Dog Man

CM Design

Remix Model

Social

Become a member

Makes

Hot Dog Man - Great designs! I printed at 50% scale and 0.16 mm height to run out my lavender spool. The leg joints were a close thing at that scale but turned out all right. - 3d model

This model is restricted by licensing terms.

View license.

130 Likes355 DownloadsJune 11, 2022

This model is restricted by licensing terms.

View license.

Get those grills ready for summer time BBQs! Did I say grills? I meant to say heat beds! Print a summer time favorite, the Hot Dog Man!

Print Settings The bun sits upright with no supports. I printed it at .2mm layer height with 15% infill. The hot dog prints on the flat side with supports holding up the over hangs. I also printed the hot dog at .2mm layer height with 15% infill.

Assembly Use some super glue on the flat side of the hot dog to glue it to the bun.

Happy Printing!