Another addition to the Welcome Pack - A piece of wall or desk art. This is of a Tiger crouching in green and orange. Created it and new I had to share the full picture.
For this Model:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Green Transmission Distance: 2
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Green
At layer #12 (1.04mm) swap to Orange
At layer #17 (1.44mm) swap to Jade White for the rest.