Hair Collection

I've had some requests for props and different options for the generic figure that I released so this Hair Collection is my third installment in a series of different collections that I plan on releasing! All of these props will fit with any of my figures :)

Printing Instructions:

• STLs already in suggested printing orientation
• No supports needed
• I would always recommend using a brim if you're not certain about the bed adhesion of any of these parts. For the heads, an inside brim is always safe and very easy to remove afterward!

Assembly Instructions:

The hairs assemble via a simple twist-lock mechanism. First, insert the lock ring into the lower half of the hair and twist clockwise to lock it in place. It doesn't matter which side of the ring is up or down, it is the same either way. Then align the top of the hair onto the bottom half and twist it into place. Just make sure when you twist it into place everything lines up correctly! There are only 3 different possible positions, so if you can't tell at first, just try one and go from there :)