Classic Spaceman

This Classic Spaceman figure is easy to print, requiring no supports, MMU/AMS, or glue and is a blast to assemble! It functions the same as my other BIG BRICK models, which are all derived from my base model: Generic Figure.

Printing Instructions:

• STLs already in suggested printing orientation
• No supports needed
• I would always recommend using a brim if you're not certain about the bed adhesion of any of these parts. In particular, the hands and arms can cause issues if there is poor adhesion. 

Filament Used In Pictures

This is a list of the filament I used while making this model. I receive no money from you clicking these links, and there may be better choices. This is just what I had available and what I thought looked good! Hope it helps :)

• Hatchbox Light Blue
• Hatchbox True Red
• Polymaker Charcoal Black
• Polymaker Orange
• Polymaker Yellow

Required Parts/Tools for Assembly:

• 3D Printed Parts [Filament]
• • Body
  • • 1x - Head [Yellow]
    • 1x - Head - Inserts [Charcoal Black]
    • 1x - Torso [Light Blue]
    • 1x - Torso - Rocket [True Red]
    • 1x - Torso - Planet [Orange]
    • 1x - Arms (brim may be helpful, connector portion may print uncleanly, this is okay!) [Light Blue]
    • 1x - Hands - Solid OR Assembly [Light Blue]
    • 1x - Waist Assembly [Light Blue]
    • 1x - Legs [Light Blue]
  • Accessories
  • • 1x - Helmet Assembly [Light Blue]
    • 1x - Air Tanks Assembly [Light Blue]

• Tools (ALL OPTIONAL)
• • Super Glue (for holding figure in one position/pose if desired)
  • Small Allen Wrench (to twist on part of waist assembly)

Assembly Instructions:

Each of my BIG BRICK models are built from the same base model and the majority of the assembly is the same for each of them. You can find detailed assembly instructions for my models on that base model's designer post here: Generic Figure. You can find all other instructions relating to this model specifically below. Enjoy!

Head: The head is pretty simple - everything just press fits in as seen in the photos!

Torso: The planet and rocket parts just press fit into the torso.

Helmet: The top of the helmet just presses down onto the lower half. It's okay if the inside of the lower half is a little messy, there's space between it and the head.

Air Tanks: The ring that goes around the neck just presses into the main body of the air tanks then slides down over the neck before the head goes on.