C-3PO

This C-3PO figure is easy to print, requiring no supports, MMU/AMS, or glue and is a blast to assemble! It functions the same as my other BIG BRICK models, which are all derived from my base model: Generic Figure.

Printing Instructions:

• STLs already in suggested printing orientation
• No supports needed
• I would always recommend using a brim if you're not certain about the bed adhesion of any of these parts. In particular, the hands and arms can cause issues if there is poor adhesion. 

Filament Used In Pictures

This is a list of the filament I used while making this model. I receive no money from you clicking these links, and there may be better choices. This is just what I had available and what I thought looked good! Hope it helps :)

• Duramic Mustard Yellow - No longer sold

• eSUN Silver
• Hatchbox True Gold
• Polymaker Charcoal Black

Required Parts/Tools for Assembly:

• 3D Printed Parts [Filament]
• • Body
  • • 1x - Head Assembly [True Gold]
    • 1x - Eyes [Mustard Yellow]
    • 1x - Mouth (optional, the cutout may look good enough to your liking)[Charcoal Black]
    • 1x - Torso [True Gold]
    • 1x - Torso - Black Part [Charcoal Black]
    • 1x - Arms (brim may be helpful, connector portion may print uncleanly, this is okay!)[True Gold]
    • 1x - Hands (may be helpful to add a brim)[True Gold]
    • 1x - Waist Assembly [True Gold]
    • 1x - Legs [True Gold]
    • 1x - Right Leg - Silver Part [Silver]

• Tools (ALL OPTIONAL)
• • Super Glue (for holding figure in one position/pose if desired)
  • Small Allen Wrench (to twist on part of waist assembly)

Assembly Instructions:

Each of my BIG BRICK models are built from the same base model and the majority of the assembly is the same for each of them. You can find detailed assembly instructions for my models on that base model's designer post here: Generic Figure. You can find all other instructions relating to this model specifically below. Enjoy!

Head: First, insert the Eyes into the head as deep as you can push them, or would like to. You can print and insert the mouth into the head as well, but I kind of liked the look without the black piece in there as well, so it's up to you! For the gold parts, line up the two horseshoe shaped pieces as shown below and snap them down over the main head part. They should click into place.

Torso & Right Leg: Both the torso and right leg have accompanying black and silver parts, respectively, that simple press fit into them.