Here is Honeycomb dish rack, This awesome honeycomb design is an incredibly fun print and a great accessory to any home, Similar to the honeycomb box this Honeycomb design is a no supports needed print in place, Just load your filament and print away, The lid comes as a separate part the idea being I could add any type of lid later on to allow for different use's and purpose's right now I just have the cutlery Lid, Print settings, no supports, Layer Height 0.2mm, Nozzle size 0.4mm, Print speed 50ms, Infill 15%, Infill pattern Grid, PLEASE BE AWARE if your using Bambu studio or Prusaslicer you need to change your line width to 0.6mm for the outer wall, 0.6mm for the inner wall, and 0.6mm for the sparse infill, this will trick the slicer into correctly printing the layers as one continuous line, also change your infill/wall overlap to 25% or higher I recommend 50%, I also recommend turning off Detect narrow internal solid infill. These settings are under the quality tab and Strength tab in Bambu studio after turning on advanced.