Here is Desk Mount phone holder 360 degree, This awesome design lets you attach your phone to your desk or table and position your phone in any direction vertical or horizontal, The design is designed to be tight enough to hold your phone in position with gravity but not straight out, To assemble the design Screw the Threaded screw into the base desk clamp then Clip the round nut onto the end of the threaded screw I recommend Heating the end of the nut with a heat gun to allow easy connection, as the nuts are designed to be as tight as possible, Then Get the Phone clamp centre piece and put the smaller threaded screw into it, Then use the square nut and clamp that onto the ended of the threaded nut, Finally attach the swivel connectors together you'll need at least 4 of the swivel connectors,
Print settings supports needed for the Desk Clamp, Use Supports normal Overhang angle 20%, no Supports needed for the threaded nuts or clamps just print them flat head down, Print speed 100mms, Infill 20%, Nozzle Size 0.4mm, Layer Height 0.2mm,
