Dolphins at Sea - Filament Painting
AVAILABLE FOR COMMERCIAL RESALE WITH TIER 2 - V2 FRAME ONLY (150x200)
This is a Hueforge filament painting of Dolphins using only 4 basic colors, that I created to showcase the Ultimate Hueforge Frame V2 150x200. This model has the 158x208 plate already assembled so you can just print this and the V2 frame linked above and are ready to go. This is a quick 4 color print that can easily be done by people with or without AMS units. .
IMPORTANT: READ BEFORE PRINTING
I have uploaded two 3MF profiles. One for people with an AMS and one for people with NO AMS.
To print with 1 AMS units all you need to do is load the colors in order and print.
To print with NO AMS unit you just need to do manual filaments swaps every color. The 3MF is set to pause at the correct layer heights. At each pause load the next filament color in order by following your unload/load procedure for your particular printer, then hit resume. Repeat until complete. This will be once per color over the entire painting. You have a decent amount of time between swaps.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. There are some recommended speed changes in my 3MF files and a layer height modifier to print the first 0.64 mm @ 0.16 mm layer height to speed up the print as there is no blending on those layers. If you don't use my profile set your layer height modifier after you have set your color swaps/pauses as it changes the total amount of layers once sliced or use the layer height value instead that number will not change ex. at (0.88 mm) swap to Blue Gray.
Filaments Used: PLA Polylite Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3.1 PLA BAMBU CYAN Cyan Transmission Distance: 5 PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Blue Gray At layer #11 (0.96mm) swap to Cyan At layer #15 (1.28mm) swap to Jade White for the rest