This is the same basic idea as the other Ultra Ball Pokebox that I have, but I reversed the hinge on it to open like an actual Pokeball. Or at the very least, how I kept trying to open it as I used it! I decided to create a new design instead of putting these files into the previous design so I wouldn't bloat the files and cause any confusion. Same instructions and parameters as the other as well.

All the same kudos and shout outs go to 3D-Printing-World and How2Texan for models and design ideas!!

Instructions:

Slicing done with Ultimaker Cura

I printed everything at .16 layer height because I wanted a finer end product for my deck box that required very little post processing

The Ultra Ball Insert, Ring, Catch, and Button were printed at 100% infill.

The Base, Lid, and top/bottom Lööps were printed at 5% Gyroid infill with 3 perimeters.

Supports were needed for the lööps, the button, and the Lid itself. The button could probably have been printed with no supports, but like I said I wanted very little post processing.

For the combined lööp and bottom, I used the same parameters as above!

Oh! And don't print the assembled model. Tis just for reference!