Ace G54 followers

Thinner Minimal Baseplate 4x4.stl

1.3K downloads · 4 years ago · An extra thin version of the minimal base plate*. Uses about half the filament as the standard 4x4 b

Description

An extra thin version of the minimal base plate*. Uses about half the filament as the standard 4x4 baseplate. Smooth underside.

If you want other sizes (eg 5x3, 2x4) use the .f3d file in Fusion 360 to change the rectangular pattern. Or maybe message and ask me nicely :)

*Minimal base plate = What you get when bare gridfinity frames meet magnet baseplate.

Tags:

Discussions

lukewbolinger2 years ago

@ace g Is there any way you could make this file a 3x4? I need it in this size and am having lots of trouble with Fusion 360... Thanks!

fleXXo2 years ago

Hey, I am a bit lost with the Fusion 360 file. Which pattern do i have to change?

DuckCat3 years ago

Thanks so much for this! I used the .f3d file to make a 5x6 grid, and then removed the magnet holders from the ones I didn't need it on to save time & filament. Would you consider releasing an .frd file of extra thin version without the magnet holders? I was able to remove most of the material but not all of it (at least not without trying to figure out the corner curve). Thanks so much!!

Trickyhicky4 years ago

I hate to say @Ace G it but i'm getting the error message in the Fusion 360 file. 3 Reference failures. The Body Reference is lost, try editing this featureto reslect the host body.

Ace G4 years ago

Ah, not surprising. I'm brand new to Fusion 360, and I know just enough to be dangerous. I think the issue was that as I'm learning by doing, there are a lot of extraneous steps. Anyway, I THINK its fixed now. Thanks for the heads up!