**Wind Spinner Balloon** This model looks like a balloon but its actually a Wind Spinner. It prints all as one piece without supports. I used helper disc’s(brim), to make sure I had enough bed adhesion. I did not use z-hop but that might help keep the fins stable while printing if you have this issue. Your printer will also need to ability to make a 1” bridge. The model as downloaded is 232mm tall but I’ve printed it at 200mm and 300mm, I’m sure you could go taller or shorter than that. I used these [Ball Bearing Swivels]( https://amzn.to/3b6cWm6)(aff) to allow it to spin better. Printed on the [Muldex]( https://github.com/3dprintingworld/MULDEX) rep-rap IDEX printer with [Eryone Matte Dual Color PLA]( https://amzn.to/3Odkfaf )(aff). _FYI… its PLA so keep out of the sun/heat._ ___ **Support and Licensing** If you would like to help support more free models, or get permission to sell physical copies of my models, consider joining my [Patreon]( https://www.patreon.com/3dprintingworld)