Mateusz K
Mateusz K

DnD Dice Holder - Dice Holding Sword

by
3dcreationzone
3dcreationzone
3dcreationzone
3dcreationzone
|
Image 1 of 7
DnD Dice Holder - Dice Holding Sword 3d model
3dcreationzone
3dcreationzone
|
Image 1 of 7
DnD Dice Holder - Dice Holding Sword 3d model
2D
3D
Makes
DnD Dice Holder - Dice Holding Sword 3d model
DnD Dice Holder - Dice Holding Sword 3d model
DnD Dice Holder - Dice Holding Sword 3d model
DnD Dice Holder - Dice Holding Sword 3d model
DnD Dice Holder - Dice Holding Sword 3d model
DnD Dice Holder - Dice Holding Sword 3d model
DnD Dice Holder - Dice Holding Sword 3d model

DnD Dice Holder - Dice Holding Sword

Sword is designed to store 1 set of DnD dice (D20, D12, D%, D10, D8, D6 and D4) set where D20 size is 20mm from the flat sides, or 23mm in diameter from the corners.

Object to print: 1xBlade - available in two versions 1xGuard - only needs supports 1xHandle 4xConnector 1xPommel 1xScabbard

Notes before printing:

  1. Almost all files can be printed without supports. Add supports only to guard.stl (while doing so, be careful not to add supports to the center of the holes)
  2. I recommend printing guard.stl and blade.stl files with a maximum of 15% fill. This is due to the fact that the joining should fit well
  3. Joining blade.stl and guard.stl is very simple. You don't need to push the connector completely into the piece, insert it so that it doesn't fall out and then join the two pieces together