The Nutcracker Box
It's another Christmas box but here I really wanted to think... Outside of the box (pun intended) and try something unique.
As you can see the wires that go from button to button are pieces of filament. There is also a "lazy" version where the buttons and wires are printed in one piece.
Note: Scaling down and using filament as wires cannot be scaled down too much as the filament wont fit the holes. Generally speaking scaling down too much will make things tighter.
Assembly:
The buttons need a drop of glue and are aligned easily in dedicated holes. The holes in the buttons for the filaments need to face each other as you can see in the images. Box has a stripe version and no stripe version - Pick which one you like better.
The wires:
This part might take several minutes 😅 The length of each peace should be approx. 5.5cm. You need 9 pieces. You then bent one side just a little bit against it's curve and push it in from both sides.
Like I said - There is also an easy one part print if you prefer.
no supports, infill is quite irrelevant you can go with 10%, 2-3 walls.
The Nutcracker Box
Beerboard
Screaming Cactuses - Part II
Screaming Cactuses - Part I
Bad Easter Bunny
Bunny Flip Stash
Horror Bunnies - The Bunny In The Mask
Horror Bunnies - Ghostface
Horror Bunnies - Jason
Art The Pint
Easter Nightmare
Death By Carrot
Tree Trunk Lamp
Bad Leprechaun
Armored Banana Case
Bad Penguin
Bad Teddy
Till Death Catchall Tray
Ace's Skull
Teddy Bear Ring Box
