tracking pixel
Michael T

The Grinch Middle Finger

by
3DGeex
Follow
Follow
Remix Model
3DGeex
3DGeex
|
Image 1 of 8
The Grinch Middle Finger 3d model
3DGeex
3DGeex
|
Image 1 of 8
The Grinch Middle Finger 3d model
2D
3D
Makes
The Grinch Middle Finger 3d model
The Grinch Middle Finger 3d model
The Grinch Middle Finger 3d model
The Grinch Middle Finger 3d model
The Grinch Middle Finger 3d model
The Grinch Middle Finger 3d model
The Grinch Middle Finger 3d model
The Grinch Middle Finger 3d model

Middle Finger is Back by popular demand in a Christmas Edition😅 I had many requests for this so it had to be done!

The hand is print-in-place - While printing it should be easier than the original middle finger (Which was also pretty easy) - all recommendations from the MF print are relevant here as well - Print slow, watch flows and so on...

Sleeve and Cuff are optional addition but it adds a lot to the looks :) You attach it using some glue - But don't glue the fingers from the bottom - just the sides.

Scaling: This hand has less mass than the original MF cause it's thinner and the default size is smaller, But the finger extends more. The finger this time has 2 walls so if you scale down - do not scale below 85% as finger will become a single wall. Scaling up should not be a problem.

3D PRINTING SETTINGS No supports 10% infill 2-3 walls Finger considerations:

If the finger wobbles:

  1. Use glue / make sure your adhesion is good
  2. lower speed
  3. Enable z-hop
  4. Check Z height make sure it's not to close to bed

if walls get fused:

  1. reduce flow / width of first layers
  2. make sure you don't have an elephant foot
  3. Randomize your Seam

9 Likes16 DownloadsJuly 24, 2024