Snowman

I couldn't think of a good name for him so it's just Snowman! (Unless you come up with a better name)

Printing:

Both head require supports - use tree/organic supports Head with connector to spine can get a bit tricky to print because the connector parts might get disconnected. Try the tips below:

• Slow down your print
• Use a brim with 0.1 or even 0.0 distance
• Use support for internal connector as well
• Use glue

Both hats require supports.

All other parts - No supports. Scaling down - Will be tricky, Scaling up - No problem.

If something doesn't fit - scale up/down by 1%-2% All parts print separately except some that require AMS (or just print in one color) You will need a few drops of glue for some parts - Adjust the hands BEFORE using glue.