.jpg&w=3840&q=75)
No Halloween without a few Jack-o'-Lanterns! This is Jack's Skull!
You can print the whole thing or just the skull part which is a full design on it's own! No AMS required here and you can put a tealight inside.
Printing:
-
Print the skull with some supports mainly under the upper eyes and below the eyes. You can probably go without supports as well but would look a bit worse and wobbly at some areas.
-
Left and Right parts require supports and they hold a big part in the air so check out the last image for a recommendation on how to print it - Basically create a custom support going from the bottom to the lower part of the mouth to make the supports nice and sturdy.
-
Stem goes inside the Top without glue - one way to push it in.
-
Pumpkin parts connect without glue
-
Use 3 walls for the Pumpkin
-
2-3 walls for all other parts
-
10%-15% infill
I added 2 skulls one without the lower cut if you wanna print it full or in a different orientation.
Working on 2 more Jack's ATM 🎃