Someone asked a few months ago to design something that goes with the dumpster so here is the Evil Rat! A few important notes about this guy:
Create a single custom support for the body where the head attaches - Image in discord channel.
At 100% he is huge so scale him accordingly before you print - These ones were printed at 80% & 70% and I also tested 60%.
The feet spin 360 degrees so it can take him out of balance if they are not facing the correct direction. These models usually have the feet facing a single direction to make things easier so if you want me to fuse them let me know here in the comments or Discord.
Better to Print the body with a higher infill than the head let's say 15%-20% body and 5%-10% head.
Avoid using a Brim for the body unless you have to - and you probably should use a brim for the head and tail.