Collapsing Middle Finger Keychain
Members Only Model
Ok here it is, made a change to 2 sections instead of 3 and removed some details that wont be seen that small and made the print jaggy. Also made a gazillion tests to make sure it's printable at small size. It's 5 cm but you can scale it up a bit (did not try smaller).
Here are some tips:
-
Print SLOW - I doubt that you'll be able to print it at 500mms crazy speeds - I printed at 30mms for initial layer and outer walls and 60mms for infill/inner walls.
-
ADHESION - use glue if you need as the parts are tiny.
-
Z-offset - make sure you are not to close to the bed or else nozzle will tip the finger eventually
-
First layer flow - if you are over extruding the walls will fuse
-
Elephant Foot - Big no no
The first layers are the most important. When the print finishes you may need to give it a push from below for it to release it. If you see no separation between the parts - Get back to the sections above 🥲
Have fun
Beerboard
Screaming Cactuses - Part II
Screaming Cactuses - Part I
Bad Easter Bunny
Bunny Flip Stash
Horror Bunnies - The Bunny In The Mask
Horror Bunnies - Ghostface
Horror Bunnies - Jason
Art The Pint
Easter Nightmare
Death By Carrot
Tree Trunk Lamp
Bad Leprechaun
Armored Banana Case
Bad Penguin
Bad Teddy
Till Death Catchall Tray
Ace's Skull
Teddy Bear Ring Box
