Members Only Model

Ok here it is, made a change to 2 sections instead of 3 and removed some details that wont be seen that small and made the print jaggy. Also made a gazillion tests to make sure it's printable at small size. It's 5 cm but you can scale it up a bit (did not try smaller).

Here are some tips:

1. Print SLOW - I doubt that you'll be able to print it at 500mms crazy speeds - I printed at 30mms for initial layer and outer walls and 60mms for infill/inner walls.

2. ADHESION - use glue if you need as the parts are tiny.

3. Z-offset - make sure you are not to close to the bed or else nozzle will tip the finger eventually

4. First layer flow - if you are over extruding the walls will fuse

5. Elephant Foot - Big no no

The first layers are the most important. When the print finishes you may need to give it a push from below for it to release it. If you see no separation between the parts - Get back to the sections above 🥲

Have fun