UPDATE 12/23/23 - Changed Grinder/GrinderLid, now just two pieces, instead of needing to insert 21 grinder blades, not as structurally strong, but I've tested it on some pretty dense/dry flower and didn't have any issues and it actually grinds pretty well..

We’ve all been there, we want to sneak some smoking herbs that are legal in our jurisdiction into a place such a crowded shopping mall, church or school, but can’t think of a discreet way to do it. Well, now you can. Cleverly disguised as a common American handgun, the SMOCOM will allow you to sneak legal smoking herbs into anywhere your heart desires, and with a lighter, odor suppressor, pre-roll storage as well as detachable herb grinder, you will always be ready for an Active Stupor ™©® situation, all you need is a Bic EZ Reach lighter, and you’re ready for anything!!!

In addition to the Bic EZ-Reach Lighter, you will need 2X 3mm heat set inserts, an M3-6 and an M3-20/25 screw, depending on how far you seat the trigger insert and 6x 8x2mm disc magnets.

PRINTING NOTES I use a 0.125 layer height with 0.25 base layer (other heights may work, but some of the tighter tolerances are probably going to need that 0.125 layer height to work well, although I haven't tested other layer heights), on my P1S a entire pistol takes about 14.5 hours to print. Lower can be printed upside down or upright and tilted. I prefer upside down, since tilted usually leaves weird overhang artifacts on the grip protrusions, although in a future version I may update the grips to be at an angle that won't require support when printed vertically. The included .3mf file is my exact setup when I'm printing an entire pistol at once.

Not for commercial use, if you'd like to buy one, go to http://3DFinesse.com, if you'd like to licence the design commercially, contact me at Alex@AlexMakesMedia.com