These Python AMS logos look AMAZING embossed on the Heated Enclosure. These enclosure cutout seals are a REMIX from the Python AMS Heated Enclosure designed by Hume Beam. Print them in any colors!
These enclosure cutout seals are in used in the heated enclosure cutouts where a dryer is not used to fully seal the enclosure. If two PolyDryers are used in the front of the enclosure. You then must seal up the rear cutouts with the cutout seals. Print as many of these (front & rear of each) you need for your specific setup.
Print using 3-5 walls and an infill of around 15%. I used supports at this orientation in the 3MF file. These are printed in PETG.
Also check out the alternate version: https://makerworld.com/en/models/805828#profileId-746339
Enjoy!