FaucetFalls

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2983014.

This should be a tight fit to 24mm faucet-outlets.

Since my one and only printer is set up for fine prints atm and not for speed, i did not testprint this one YET.

If someone is eager to try, according to the slicer (ideamaker) it should take ~22g. (.2 nozzle, .1 layerheight, 10% infill, 6 shells, 6 bottom, 8 top = ~12h print) ^----these are my actual settings, would be a waste of time for this very unfine object...