The Snowflake Ornament

Prints in 8 separate pieces flat on the build plate and assembles afterwards, great for hanging on the tree or as general Christmas décor.

Approximate print time is 3.5-4 hours depending on print settings. No supports needed.

You will need to print: (1) Center Shaft (1) Center Flake (2) Flake 1 (2) Flake 2 (2) Flake 3

After printing, just slide the flakes up onto the center shaft in whatever order you want. When the flake your installing has passed the peg on the center shaft, just rotate and slide down to lock it into place. You can feel free to use a dab of super glue at the joints if you want it to stay together better.

This file is uploaded with a Non-Commercial license, but I do allow commercial use of this and all of my other files to my Patreon supporters.

https://www.patreon.com/thinair3D

Here are the settings I used:

Nozzle: 0.4 Infill: 10% Perimeters: 2 Supports: None