A little bird with flappy moveable wings that can lock into a raised position for fun poses just like the dragon. The 3MF files are pre-painted as seen in the photos. Multipart files have the eyes, beak, and claws parted out. Prints in place with no support.

Please consider supporting my work with a Thangs membership. Memberships include commercial licensing to sell physical prints of all tinymakery designs.

Files included:

• unibody STL (single part printing)
• unibody 3MF (single part multicolor printing)
• multipart STLs (separate part printing and assembly)
• multipart 3MF (multicolor separate part printing and assembly)

Print settings and recommendations:

• 3 walls at 0.4mm nozzle size
• 40-60mm/s outer wall speed recommended
• 15% infill (adaptive cubic, cross hatch, or gyroid)
• no supports, slow down for overhangs enabled
• no brim unless encountering adhesion issues
• PEZ / polyurea plate recommended
• 80% scale tested

Licensing: These model files are for your personal use only. Holding an active Thangs membership status grants you commercial licensing to sell physical prints made with these model files. Files are not to be shared or resold. Modifications may only be made for personal and non-commercial reasons.