tracking pixel
Trevor M

Ender 3 Klipper Enclosure Pi Zero

by
tbmallow
Follow
Follow
Remix Model
Ender 3 Klipper Enclosure Pi Zero 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 17, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4960782.

This is an enclosure I came up with to house the main board and a Raspberry Pi Zero WH for my Ender 3 after updating to Klipper firmware. Klipper does not utilize the main board sd slot so I made a nice uniform front face. I also made the enclosure accessible from the top or the bottom. It uses a 4020 fan that is just slid down over the pins. This has worked well for me with the fan pulling air down and out of the enclosure. I printed at 10% infill, 0.2 layers, 4 bottom 5 top layers, 2 perimeters.


0 Likes3 DownloadsOctober 17, 2021




This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 17, 2021
This model is restricted by licensing terms.