Mounts a 5015 fan for the heatbreak and moves the cr touch inline with the nozzle on the left side. Clears the gantry.

Set heatbreak fan to 50% fan speed for ultra quiet operation.

X-Offset is -50.7

Ender 3 S1 5015 fan mount with left side inline cr-touch

Mounts a 5015 fan for the heatbreak and moves the cr touch inline with the nozzle on the left side. Clears the gantry.

Set heatbreak fan to 50% fan speed for ultra quiet operation.

This is intended for the 18mm orange silicone spacers. These return the bed to around the original spring height so bed insulation will clear the y-axis mount. It also stabilizes the silicone horizontally. The squishy silicone side goes against the bed heater.

Silicone Spacer Stabilizer

Mounts a 5015 fan for the heatbreak and moves the cr touch inline with the nozzle on the right side. Clears the gantry.

Set heatbreak fan to 50% fan speed for ultra quiet operation. You will need to extend the CR Touch wires.

x offset=37.687

Ender 3 S1 5015 fan mount with right side inline cr-touch

Ender 3 S1 5015 fan mount with inline cr-touch

Y-Axis Stepper Motor Mount for the Creality Ender-3 S1 and S1 Pro

This makes use of the spare "z-axis end stop" included with the printer. The regular y-axis end stop has no mounting holes in the pcb and is a flawed design for silent operation.

The tolerances where the extrusion inserts into the mount are tight so it will not rattle at high speed. I would print with this feature facing up.

Ender 3 S1 Y-Axis Silent Stepper Motor Mount

Y-Axis Stepper Motor Mount for the Creality Ender-3 S1 and S1 Pro

Ender 3 S1 Y-Axis Stepper Motor Mount

This is a tray to hold a Raspberry Pi 3B+ in the standard drawer location of a Creality Ender-3 S1.

The nubs that the Pi fits on are intended to be melted with soldering iron to fix the pi in place with no hardware (hot glue works too).

The long slots on the sides are to allow the the drawer to open with wires going to either the screen or for power. The metal box the drawer slides into will need holes drilled in whatever location for the wires you choose.

Creality Ender-3 S1 Klipper Octoprint Raspberry Pi 3B+ Tray

This is a tray to hold a Raspberry Pi 3B+ in the standard drawer location of a Creality Ender-3 S1.

The nubs that the Pi fits on are intended to be melted with soldering iron to fix the pi in place with no hardware (hot glue works too).

The long slots on the sides are to allow the the drawer to open with wires going to either the screen or power protruding from the sides or back. The metal box the drawer slides into will need holes drilled in whatever location for the wires you choose.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

Blu-Square

Ender 3 S1 5015 fan mount with left side inline cr-touch

Silicone Spacer Stabilizer

Ender 3 S1 5015 fan mount with right side inline cr-touch

Ender 3 S1 Y-Axis Silent Stepper Motor Mount

Creality Ender-3 S1 Klipper Octoprint Raspberry Pi 3B+ Tray