Nikon EN-EL3e Battery Cover ( EN EL3 EL3e )

Nikon EN-EL3e Battery Cover

Ball Head For Table Legs And Corners

If the ball it's too loose add a little bit of paper in the socket

ball_head_ball_low_clearence.stl

Z axis height calibration

Stands for Z axis level (8 mm smooth rod on X)

Print two copies of this thing and you could easliy level your X carriage.

Put them close to the Z axis motors, they will engage the lower 8 mm X carriage rod

Procedure:

Jog your Z axis up to 30 mm

Place the stands on your printer

Jog your Z axis down until both stands are engaged and pressed by the rod

Lift Z axis 20 mm

Remove the stands

Done, you're ready to print or level your bed :)

Raspberry Pi Zero W V1.1 Slim case

PiZeroW_V1.1SlimTop_GPIO_HS15x14_LED.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

PhotoCroMax

Nikon EN-EL3e Battery Cover ( EN EL3 EL3e )

Ball Head For Table Legs And Corners

Ball Head For Table Legs And Corners

Z axis height calibration

Raspberry Pi Zero W V1.1 Slim case