Netflix and Chill led sign

I designed this using 3D Builder. It's been printed on E3P and it was easy to print, doesn't require any supports.

Print Letters upside down for the best results.

Letters and Base should be tight fit. Push Letters in the Base until you reach the edge. You can use glue if needed. Install led strip into the Cover. There is an exit hole for cable to go out. After that glue the Base to the Cover. Make sure both parts are aligned.

I printed all parts at 0.28mm layer height.

Eryone PLA+ white/black. 12v RGB led Super Glue

*Non-Commercial Use ONLY